pugheaven
Post #1
So as most of you are aware im either stripping the entire dimma or going down the evo engine and running gear route.If I go down the evo route the following will be for sale...
Dimma front wide track kit.
.Wishbones powder coated black with 2000 mile old ball joints and rich w roller bearing bush's
.dimma drive shafts
.mc phearson top mount plates
.track rod extensions
£1500
-2 degrees camber hubs powder coated black with 2000 mile old skf wheel bearings £220
18x8 revolution millenium wheels with ns2r tyres, wheels and tyres covered 200 miles
£700
Brand new in box 18x8 revolution millenium wheels £500
AP racing 4 pot calipers with 310mm bell and rotors
£1100
Wp pro rear big brake kit 310mm discs and adapter
£250
Custom upper strut brace which hugs the bulkhead
£70
Gaz gold coilovers covered 2000 miles
£450
Rear beam
Full rebuild including all new bearings, seals, trailing arm shafts, every nut bolt and washer (all genuine pug parts with invoice got over £45000 for parts)
30mm ARB
22.5 torsion bars
Baker bm solid mounts
Bridgecraft -3 degrees negative camber
Bridgecraft custom wide track kit
Every part has been powder coated
£750
Phillip m drop links powder coated black covered 2000 miles all the bearings in the rose joints are as new
£70
Phase 1 2.4 vts rack
£150
Quaife diff
£400
Satchshift, as new only 1500 miles
£300
Helix paddle clutch and cover plate (clutch has done 2000 miles since being re plated by Helix)
£100
Super high boost engine with c38 81 charger oil lines 13 row cooler, DTA S60 ecu, custom ecu alloy box, bt Bluetooth adapter for DTA app.
Bottom end got rebuilt 2000 miles ago by rich with lots off new parts and invoice showing over £500
Loads of power coated, plated and anodized parts
All ways run on royal purple oil.
Spoox blue silicon oil and water hose kits
Engine loom and all associated parts
Can be seen running, any checks can be done before purchase (compression test etc)
Running 446 hp before the restrictor was opened up
£5000 which is less than half the price it costs (invoices to prove)
Gti6 exhaust manifold ceramic coated in grey £350
Custom Torque techniques 3" centre exit manifold back system only covered 1400 miles max
Entire system is heat wrapped, water repellent sprayed
£650
KAD straight cut 3rd and 4th gears set? Will get miles to remove them from the box and inspected
2000 miles use, always used the clutch
£700 ono
Metal exhaust manifold heat shield powder coated black (not the new style ones that Ryan is selling, this one is one of the ones Simon had made, compare the two and make your own decision on which ones better)
£60
Custom 6 point bolt in roll cage (will require box sections welding in for the feet to bolt to) with double door bars and rear legs going to beam mounts, powder coated black
£600
Vibratechnics race top engine mount,gearbox mount, solid rear mount 2000 miles use
£200
Iv had loads of messages requesting for parts but for ease can ppl post on here what you would want
Posted 23rd Apr 2016 at 19:00
