Water leak in my lovely gti6 sieve - General Forum - Peugeot 306 GTi-6 & Rallye Owners Club

displaying posts 1 to 25 of 80

Pages (4): [1] 2 3 .. last

Author

Subject: Water leak in my lovely gti6 sieve

superchargedblack1997gti6

Seasoned Pro

Location: guildford

Registered: 15 Aug 2009

Posts: 2,376

Status: Offline

Post #1

Hello guys trying to find the leaks in my car Thumbs down

I have tried the drain holes in the scuttle panel both of these are clear.
the aircon pipe bung has a hole for an power cable so needs siliconing, I have silicones and sealed the aerial base.
is there anywhere else I'm missing as I'm beginning to feel like setting fire to it LOL

water is gathering in both footwells and has got that bad recently that the battery symbol was lit in the dashboard even with keys removed and ran my batterry right down so I'm a bit miffed having to disconnect the batterry every time i park up

thanks in advance of any help guys Thumbs up

________________________________________

Super high boost Completed, destroyer of gearboxes and 160mph club

Posted 24th Dec 2013 at 15:17

Profile

jord294

Seasoned Pro

Location: somewhere in north wales

Registered: 09 Nov 2009

Posts: 3,110

Status: Offline

Post #2

Time to break it I think Yes

________________________________________

FRESHLY RE-FURBISHED GTI BEAMS
FITTING AND LOWERING AVAILABLE.
ALL AXLES BUILT USING GENUINE PEUGEOT PARTS

IF I'M NOT HERE, IT ONLY MEANS ONE THING.... I'M SOMEWHERE ELSE!

Posted 24th Dec 2013 at 15:32

Profile

superchargedblack1997gti6

Seasoned Pro

Location: guildford

Registered: 15 Aug 2009

Posts: 2,376

Status: Offline

Post #3

no mate I enjoy it and to be fair if I can't find the leak spots it'll just be silicon gun out and go mad but It would be handy if I can get to the bottom of it. But Jord I promise the Kws to you when I break Thumbs up

________________________________________

Super high boost Completed, destroyer of gearboxes and 160mph club

Posted 24th Dec 2013 at 15:41

Profile

stan_306gti6 Forum Admin

Location: Kent

Registered: 18 Jan 2004

Posts: 21,768

Status: Offline

Post #4

Both front door seals I reckon. Yes

________________________________________

"Supercharged - 454.1bhp/317.5lb/ft"
Peugeot 306 GTi-6
2000 (X), Moonstone Love

Posted 24th Dec 2013 at 16:16

Profile

superchargedblack1997gti6

Seasoned Pro

Location: guildford

Registered: 15 Aug 2009

Posts: 2,376

Status: Offline

Post #5

cheers Stan I'll get on the case with that in the morning! is that a case of remove then clean and replace?

________________________________________

Super high boost Completed, destroyer of gearboxes and 160mph club

Posted 24th Dec 2013 at 16:28

Profile

darkgti6

Seasoned Pro

Location: Bracknell

Registered: 07 Jun 2008

Posts: 1,361

Status: Offline

Post #6

stan_306gti6 wrote:

Both front door seals I reckon. Yes

Mine did this so i replaced both at great expense.... and they still leaked Thumbs down

________________________________________

Team Peugeot Sport 308 Gti�

Black T'99 Gti - may she rest in peace - written off in a shunt on the A329m

Posted 24th Dec 2013 at 16:29

Profile

jimmyrallye

Seasoned Pro

Location: portsmouth

Registered: 19 Apr 2008

Posts: 3,144

Status: Offline

Post #7

Stab the door sills and see if water comes out of them thats what was happening on my 6

________________________________________

"Police arrested two kids yesterday, one was drinking battery acid, the other was eating fireworks. They charged one and let the other one off."

Posted 24th Dec 2013 at 18:22

Profile

bigbadbowen

Seasoned Pro

Location: Winchester

Registered: 21 Nov 2003

Posts: 13,753

Status: Offline

Post #8

Remove both door seals squeeze the gap bit that attaches to the car and then reattach to the door frames Thumbs up

Posted 24th Dec 2013 at 20:50

Profile

woody.

Senior User

Location: London

Registered: 18 May 2009

Posts: 799

Status: Offline

Post #9

Mine was leaking and turned out to be leaking down the inside of the door and coming out of the door card into the car. Is there still that plastic sheet inside the door?

Posted 24th Dec 2013 at 21:05

Profile

stan_306gti6 Forum Admin

Location: Kent

Registered: 18 Jan 2004

Posts: 21,768

Status: Offline

Post #10

The plastic membrane is rather important, but it is more for wind noise than water protection as the membrane isn't waterproof.

I'm still voting door seals, these are a very common fault.

________________________________________

"Supercharged - 454.1bhp/317.5lb/ft"
Peugeot 306 GTi-6
2000 (X), Moonstone Love

Posted 24th Dec 2013 at 21:28

Profile

mik

Seasoned Pro

Location: Kent

Registered: 17 Feb 2011

Posts: 2,100

Status: Offline

Post #11

Depends on your definition of 'waterproof'. The membrane stops water that runs through the door soaking into the door card and leaking into the interior. If damaged or missing due to ham fisted stereo installations or other bodged repair the car will leak. Guaranteed.

________________________________________

Cherry Rallye SOLD

Posted 25th Dec 2013 at 15:46

Profile

superchargedblack1997gti6

Seasoned Pro

Location: guildford

Registered: 15 Aug 2009

Posts: 2,376

Status: Offline

Post #12

Well I have now sealed the aircon pipe bung that had a 2 inch hole in it. I await the interior drying out do that I can see where else I need to seal up. So the membrane just stops water shopping on the door cards and soaking through then onto the floor. Maybe I'll just take the door cards off for a while and see if the problem is no longer there. Cheers got the help. Is there any more bungs from engine bay to interior that I may have to seal up? Thanks for the advice though

________________________________________

Super high boost Completed, destroyer of gearboxes and 160mph club

Posted 25th Dec 2013 at 17:34

Profile

Niall

Seasoned Pro

Location: Epsom

Registered: 06 Jun 2012

Posts: 1,941

Status: Offline

Post #13

Check the drains in the bottom of the door are unblocked and also as others have said, make sure the door membranes are sealed up. Im having the same problem at the moment and have a roll of that door membrane material on order.

Posted 25th Dec 2013 at 18:38

Profile

bigbadbowen

Seasoned Pro

Location: Winchester

Registered: 21 Nov 2003

Posts: 13,753

Status: Offline

Post #14

I sorted the water leak problem on my rallye by removing all the door seals and then refitting them after squeezing the channel to make them a good tight fit ! Use a small hammer to reattach them to the car

Posted 25th Dec 2013 at 19:30

Profile

pugheaven

Seasoned Pro

Location: Fareham

Registered: 17 Dec 2006

Posts: 4,602

Status: Offline

Post #15

Door seals might be the culprit however if it's effecting the dials and fuse panel I would guess that its the sunroof leaking, the water running down the roof lining, down the a pillar and behind the dash, maybe pop the a pillar trim off and put some tissue in the gap to see if water is getting in that way

Posted 25th Dec 2013 at 20:51

Profile

calibra306

Seasoned Pro

Location: Gravesend, Kent

Registered: 06 Nov 2011

Posts: 1,315

Status: Offline

Post #16

My leak was from windscreen seal right in the top passengers side corner! It gathered and run out the center top light fitting.

Once the roof lining was removed it was evident where it was dripping from when it rained.

________________________________________

V6 Power!

Faster I can go the better!

Its not what you drive, its how you drive that wins the race!

Posted 25th Dec 2013 at 21:29

Profile

superchargedblack1997gti6

Seasoned Pro

Location: guildford

Registered: 15 Aug 2009

Posts: 2,376

Status: Offline

Post #17

no longer leaking up high it's now down low. I soaked 5 towels out of the footwells and have got a heater in it overnight to dry out. I'll keep you guys posted, I can see that the membranes on the door could well be an issue too! I've not owned a sunroof car before but when investigated didn't seam to be any leaks once I'd completed the Ariel seal replacement. Thumbs up

________________________________________

Super high boost Completed, destroyer of gearboxes and 160mph club

Posted 25th Dec 2013 at 23:08

Profile

stan_306gti6 Forum Admin

Location: Kent

Registered: 18 Jan 2004

Posts: 21,768

Status: Offline

Post #18

If it's low down it will be the front door seals. Yes

That's the only other major common issue which is low down as opposed to the normal issues involving the sunroof or aerial base.

________________________________________

"Supercharged - 454.1bhp/317.5lb/ft"
Peugeot 306 GTi-6
2000 (X), Moonstone Love

Posted 26th Dec 2013 at 07:29

Profile

superchargedblack1997gti6

Seasoned Pro

Location: guildford

Registered: 15 Aug 2009

Posts: 2,376

Status: Offline

Post #19

I am also going to get the heater matrix changed just to make doubly sure that I fix this problem once and for all. can anyone confirm that his behr one from euros is correct?
http://www.eurocarparts.com/ecp/c/Peugeot_306_2.0_1997/p/car-parts/car-cooling-parts-and-car-heating/heating/heater-matrix/?214540020&1&31c58aac43711bc46ad68fdfd7e801aced09db58&000189
thanks again

________________________________________

Super high boost Completed, destroyer of gearboxes and 160mph club

Posted 26th Dec 2013 at 09:12

Profile

scotzman

Seasoned Pro

Location: Dundee

Registered: 24 Jun 2011

Posts: 1,408

Status: Offline

Post #20

That's the right one but get it from carparts4less.co.uk and use the code cp5less at the checkout. Thumbs up

________________________________________

'90 1.6 205 GTi, '98 306 GTi-6

Posted 26th Dec 2013 at 09:19

Profile

superchargedblack1997gti6

Seasoned Pro

Location: guildford

Registered: 15 Aug 2009

Posts: 2,376

Status: Offline

Post #21

Thanks mate

________________________________________

Super high boost Completed, destroyer of gearboxes and 160mph club

Posted 26th Dec 2013 at 09:26

Profile

jord294

Seasoned Pro

Location: somewhere in north wales

Registered: 09 Nov 2009

Posts: 3,110

Status: Offline

Post #22

surprised stan hasn't moved this Hmm

tough call though! would it go in interior or exterior, in technical section ??

________________________________________

FRESHLY RE-FURBISHED GTI BEAMS
FITTING AND LOWERING AVAILABLE.
ALL AXLES BUILT USING GENUINE PEUGEOT PARTS

IF I'M NOT HERE, IT ONLY MEANS ONE THING.... I'M SOMEWHERE ELSE!

Posted 26th Dec 2013 at 09:35

Profile

superchargedblack1997gti6

Seasoned Pro

Location: guildford

Registered: 15 Aug 2009

Posts: 2,376

Status: Offline

Post #23

Think it should go in The Wtf is going on section!

________________________________________

Super high boost Completed, destroyer of gearboxes and 160mph club

Posted 26th Dec 2013 at 09:55

Profile

stan_306gti6 Forum Admin

Location: Kent

Registered: 18 Jan 2004

Posts: 21,768

Status: Offline

Post #24

It's pretty much of general nature to be honest, at least until we find the cause anyway. LOL

________________________________________

"Supercharged - 454.1bhp/317.5lb/ft"
Peugeot 306 GTi-6
2000 (X), Moonstone Love

Posted 26th Dec 2013 at 10:28

Profile

coskev

Seasoned Pro

Location: Oswestry

Registered: 01 Nov 2009

Posts: 3,132

Status: Offline

Post #25

If its matrix you would smell the coolant.

has it ever had a new windscreen? Wink

________________________________________

Red GTB1756 powered Fabia VRS daily driver,LBSC Gti6 eater........

Mac1 ZR R1 kit car build in progress.

Posted 26th Dec 2013 at 11:23

Profile

Pages (4): [1] 2 3 .. last

All times are GMT. The time is now 09:04

Please Note: The views and opinions found herein are those of individuals, and not of The Peugeot 306 GTi-6 & Rallye Owners Club or any individuals involved.
No responsibility is taken or assumed for any comments or statements made on, or in relation to, this website. Please see our updated privacy policy.