|
displaying posts 1 to 2 of 2
| Author | Subject: oil breather T peice, diameters? |
 jimmyhackers
Seasoned Pro  Location: birmingham Registered: 14 Jun 2011 Posts: 1,284 Status: Offline |
Post #1
mine is snapped, planning on replacing with a custom metal unit when i remove/clean my inlet, just wonderd what sizes the barbs were?p.s. spooxracing does a billet alloy one for 189 quid  ________________________________________ the world is changed by people in sheds |
 Posted 7th Jun 2025 at 13:42
|
|
|
jimmyhackers
Seasoned Pro Location: birmingham Registered: 14 Jun 2011 Posts: 1,284 Status: Offline |
Post #2
19mm for the two smallers, 25mm for the larger one.ive ended up using a 16mm brass tee with a sleeve of rubber over the larger port/pipe. not great but the ID on the two smaller ports is almost the same as the brass walls were thinner. ________________________________________ the world is changed by people in sheds |
|
Posted 19th Jun 2025 at 18:29
|
|
The Peugeot GTi-6 & Rallye Owners Club - ©2026 all rights reserved.
Please Note: The views and opinions found herein are those of individuals, and not of The Peugeot 306 GTi-6 & Rallye Owners Club or any individuals involved.
No responsibility is taken or assumed for any comments or statements made on, or in relation to, this website. Please see our updated privacy policy. (NEW HOST)