|
displaying posts 1 to 7 of 7
| Author | Subject: tailgate screen |
 chiefton
Seasoned Pro  Location: cranleigh Registered: 09 Dec 2012 Posts: 1,195 Status: Offline |
Post #1
How easy is it to swap the window out of one tailgate to another?? Are they bonded in or something??If I could swap myself would be handy as mine is smashed and dont want the rain getting in and my temporary window almost blew away last night!!! Has anybody done this before,otherwise going to cost me 50 odd quid. cheers ________________________________________ cherry rallye daily (the money pit) |
 Posted 15th Feb 2014 at 11:08
|
|
|
mik
Seasoned Pro  Location: Kent Registered: 17 Feb 2011 Posts: 2,100 Status: Offline |
Post #2
Depends - if you have a visible seal that sits proud of the glass (a Phase 2 tailgate) it might be possible. I've got a flush bonded Phase 3 tailgate on my Rallye. I asked a glass guy as I want to remove mine as it needs painting due to a bad blow-in and the paint is going right next to the rubber (as salt gets sucked up the back when driving) so it can't be masked off. He said the glass might come out in one piece, but the rear window heater wiring connector tabs almost always get damaged. So it is pretty much a new rear window in my case. ________________________________________ Cherry Rallye SOLD |
|
Posted 15th Feb 2014 at 12:37
|
|
|
chiefton
Seasoned Pro Location: cranleigh Registered: 09 Dec 2012 Posts: 1,195 Status: Offline |
Post #3
mik wrote: Depends - if you have a visible seal that sits proud of the glass (a Phase 2 tailgate) it might be possible. I've got a flush bonded Phase 3 tailgate on my Rallye. I asked a glass guy as I want to remove mine as it needs painting due to a bad blow-in and the paint is going right next to the rubber (as salt gets sucked up the back when driving) so it can't be masked off. He said the glass might come out in one piece, but the rear window heater wiring connector tabs almost always get damaged. So it is pretty much a new rear window in my case. yeah it is phase 2 tailgate I may just pay the 50 I have a spare boot lid with window thats why I was guna see if could swap the glass over. ________________________________________ cherry rallye daily (the money pit) |
|
Posted 15th Feb 2014 at 13:10
|
|
|
mechanical_repairs
Seasoned Pro  Location: leicester Registered: 10 Jan 2005 Posts: 12,122 Status: Offline |
Post #4
All the tailgate glasses are boned in, it's just the ph1 and 2 have a rubber finishing trim where as the later ph3s don't. A competent screen guy should get it out ok.Carl ________________________________________ C.G.Cars of Leicester, Peugeot/Citroen/Renault specialist Tel: 01162 624498/07799 405184 WWW.CGCARSLEICESTER.CO.UK36 narborough road south, Leicester LE3 2fn MOT station now open, tests £35 with a free retest. Recovery available with a recovery unit, for those not so local jobs Also offer the loan of a free courtesy car 306 dturbo |
|
Posted 6th Apr 2014 at 17:13
|
|
|
mik
Seasoned Pro Location: Kent Registered: 17 Feb 2011 Posts: 2,100 Status: Offline |
Post #5
Do you mean get it out with the tabs undamaged so it can be put back in with working rear window heater? Also, I've looked on service box and it has the part no for the seal. Since Rallyes had both P2 and P3 rear hatches, how do you tell if you have the correct seal as only one part no is listed for my VIN? It is more expensive than the glass! ________________________________________ Cherry Rallye SOLD |
|
Posted 7th Apr 2014 at 08:44
|
|
|
chiefton
Seasoned Pro Location: cranleigh Registered: 09 Dec 2012 Posts: 1,195 Status: Offline |
Post #6
Well as previously said one is just bonded and the other is with a protruding seal.so phase 3 doesnt have a seal as such id imagine that why its a smooth finish with no seal showing. I had it swapped over for 50 by a bloke I know, as he was swapping them a bloke on ebay wrote to me and said I could have a complete cherry tailgate for60 delivered!!! Sods law ey never mind! ________________________________________ cherry rallye daily (the money pit) |
|
Posted 7th Apr 2014 at 09:39
|
|
|
welshpug!
Capt Pedantic  Location: Bigend, Wales. Registered: 27 Mar 2007 Posts: 25,839 Status: Offline |
Post #7
earlier ones don't have a "seal" its just a trim.________________________________________ need a part number? get on here - http://public.servicebox.peugeot.comBring on the Trumpets. |
|
Posted 7th Apr 2014 at 11:03
|
|
The Peugeot GTi-6 & Rallye Owners Club - ©2024 all rights reserved.
Please Note: The views and opinions found herein are those of individuals, and not of The Peugeot 306 GTi-6 & Rallye Owners Club or any individuals involved.
No responsibility is taken or assumed for any comments or statements made on, or in relation to, this website. Please see our updated privacy policy.