Had the car on the dyno other day so get a benchmark and see if the engine is in a healthy condition overall.

Results were 130.1 at the wheels which from what iv been told is pretty good for a standard engine??

However i was looking on this guide Club306 and states standard torque is 145.0 lb/ft @ 5500 rpm but i only got 88.1.

There has been a noticiable difference in how the car pulls lately. Also told me the clutch is just starting to slip as it took him 6 goes to get a reading. I had the cambelt done and since theres been a loud tapping noise which is audioble over the exhaust on tickover(got a vid somewhere)

Could either of the 2 result in such a low figure

Oh i see, can you work out what it will be at the fly like you can for the BHP or is it completely different?

What is the avarage figure at the fly and wheels for Torque from people that have been on the rollers?

ATW Lotek, not ATF

afraid I haven't a clue, should have asked the RR operator!

________________________________________

need a part number? get on here - http://public.servicebox.peugeot.com

Bring on the Trumpets.

Haha ye there all at the wheel figures, ill have a look thought some old threads of results and Rolling Roads see what other results are brought up.