Hi can you still get new peugeot sport h section steel rods and forged pistons
Thanks

whats fishy about it mate?

its a bottom end with pugsport pistons and rods, fully rebuilt and not been run

Don't think you can get them branded peugeot sport, but you will be able to get them. Ots also possible richard longman had a stash of them new or used.

________________________________________

Oulton Park in a BTCC 306 vid 1
Oulton Park in a BTCC 306 vid 2
Lap of the 'ring

Pistons

does not list the conrod

Why not just use Arrow and Omega, Pug sport doesn;t really exist anymore as it's been bought out a couple of time since that site was orginally done

________________________________________

306 Rallye Sptint/Race Car, 205 CTI 1.9 8v to name a few

Road, Track and Race/Rally car preparation to your personal requirements,
Full Workshop & Diagnostic Facilities
New and Second parts, from Plugs to Turbo's
We now also carry out Routine Servicing
www.pugracing.com

& FB Page, https://www.facebook.com/PugRacing

Ebay; http://stores.ebay.co.uk/Pug-Racing-Shop

2012/2013/2014/2019 Class Winners at Gurston Down Speed Hillclimb & Joint overall, Class record too along the way,

Hi all, I am looking to build a maxi ish or semi kit spec 306 for rallying, something possibly along the lines of the 1995 Peugeot UK works car driven by Martin Rowe. I know this wasn't a maxi but it only lacked the wide track. I recently contacted a guy, who shall remain nameless, regarding the forged bottom end, and have since found out by looking at the threads this is an on going saga. When the right questions were asked his story didn't seem to hold up. You dont get anything for nothing in this world. I was prepared to travel to Southampton to view the motor and requested that the sump be removed to check the rods and pistons. The spec changed over the few conversations, and the request to remove the sump was denied, I am quite well qualified to remove and replace the sump, so alarm bells rung and I left it there. I advise anyone who wishes to buy something special along these lines to ask for ample verification, builders contact details, receipts etc.
Unfortunately this got my juices going and I have started looking at pricing a pukka bottom end. If anyone is looking for the same sort of spec engine please pm me, as I am sure a discount can be arranged for a multiple sale. Just for a start the correct forged pistons and con rods can be bought for little more than this forged bottom end was advertised for. These are not Chinese and are manufactured in the UK. Anyway enough of my ramblings.

________________________________________

E reg 205GTI non sunroof maybe for sale m.o.t'd ideal rally, trackday car, also have 6 engine and box available

mmmmmm Sodemo

mark-house has attached the following image:

________________________________________

Peugeot 306 GTi 6
BMW 320 td compact M-sport
1967 Mini Cooper
1990 Jaguar XJR 4.0